ALTAAS Topologies Sdn Bhd
Unit D-8-05, Oasis Square (Building Capital 4)
No. 2, Jalan PJU1A/7A,
Ara Damansara,
47301 Petaling Jaya,
Selangor, Malaysia.
The Comet 1600R series industrial G.SHDSL.bis Ethernet extender is in compliance with EN50121-4 ETS EMC. This proves that not only can TAINET products operate and sustain on railways, but they can also work well under harsh conditions. Comet 160xR EFM series supports high-speed dedicated symmetrical data transmission and utilizes DSL bandwidth. The automatic adjusting line rate can be up to 15Mbps over 2-wire copper line symmetrically. Comet 1602R/1604R series typically works as an Ethernet extender, with up to 4 wires that could enhance the line rate and provide aggregated bandwidth up to 30Mbps.
Feature
Symmetric H.264 or MPEG4 HD quality video streaming over 3Km
Point to point Ethernet extension over multiple copper lines 1 or 2 pairs G.SHDSL.bis with 15Mbps per pairs
Supports extension rate up to 30Mbps over 2 pairs of copper
Easy installation with DIP switch, Telnet, WEB GUI and SNMP
Automatic line rate selection with Line Probe enabled
Front panel status LED indicators for easy monitoring
Front panel test button with BERT for easy loop diagnostic
Easy software upgrade for field-deployed units via TFTP
DSL line protection for data transmission
Ethernet switching and bridging with VLAN prioritization and QoS
Supports security-link
CO and CPE mode selectable
Optional Ethernet port surge protection
Compliant with IEEE 802.3ah EFM 2Base-TL bonding technology
Compliant with ITU-T G.991.2 standard, TC-PAM 16/32/64/128 line coding
Specification
Model
Comet 1602R, 2-wire, 4 Ethernet ports
Comet 1604R, 4-wire, 4 Ethernet ports
Line Interface – G.SHDSL.bis
Type: 2 or 4-wire
Standard: ITU-T G.991.2, ETSI 101 524
Bonding protocol: IEEE 802.3ah EFM 2Base-TL
Line rate: n x 64Kbps, n=3~239 (2w), 6~478 (4w)
Rate1: Symmetric 10Mbps over 3Km@24AWG (0.5mm)
Rate2: Symmetric 384Kbps over 9Km@24AWG (0.5mm)
Connector: 1xRJ-45
Line coding: TC-PAM 16/32/64/128
Impedance: 135 ohm
DTE Interface – Ethernet
Ethernet type: 10/100 BaseT
Connector: RJ-45
Supports 802.3x flow control
Auto-MDI/MDIX detection
Auto-negotiation for speed and duplex
Full duplex / Half duplex support
Ethernet L2 function
Supports 802.1d transparent bridge function
Supports Bridge filter function based on source MAC addresses
Scalable per port bandwidth control (Step = 64K, up to 100M)
2K MAC learning address
Ethernet packet length up to 1664 bytes
Supports 802.3x flow control
Provides 802.1q VLAN tagging
Supports 802.1p QoS facility
Management
Configuration via DIP switch, Telnet, WEB GUI and SNMP
Multiple Web browsers supported: IE, Firefox, Chrome
Supports remote management
Local and Remote loopback for diagnostic
Supports Performance Monitoring function
Front panel test button for easy loop healthy testing